Volume-10 , Issue-3 , Sep 2023, ISSN 2348-6341 Go Back

• Open Access   Article

  Exploring the Radiative Properties of Iron Sulfide Thin Films Deposited On Aluminium Plates at Room Temperature (300K)

  S.E. Umoru

  Research Paper | Journal-Paper (JPCM)

  Vol.10 , Issue.3 , pp.1-7, Sep-2023

  Abstract

  Full-Text HTML

  References

  Citation

  Abstract
  To increase the technical expertise of our times, material scientists and engineers must be able to create innovative materials with unusual combinations of mechanical and physical properties for harvesting solar energy. To effectively utilize solar radiation, materials are needed to trap the radiation before converting to its area of usefulness. Ability of materials to absorbed and radiate heat depends on its surface. Electroless chemical bath deposition (ECBD) approach, with a deposition time range of 12 to 32 hours, was effectively used to create thin layers of iron sulfide on cleaned aluminum sample plates. Using a thermocouple potentiometer, thermal emittance was measured on polished and coated sample plates.. The average thermal emittance of polished plates is 0.15 ± 0.01, while that of coated plates is normally between 0.151 and 0.159 depending on the deposition period.. The low thermal emittance value of the coated plates is favorably contrasted with the value obtained for selective surfaces utilizing various film deposition processes. As selective absorbers for solar energy collectors, the iron sulfide thin films that have been formed on polished aluminum plates could be useful.

  Key-Words / Index Term
  Deposition, iron sulfide, thin films, room temperature, emissivity, thermocouple, Blackbody.

  References
  [1]. Innocent, A. J.; Jacob, O. E.; Chibuzo, G. C.; James, I.; Odeh, D. O., “Estimation of Global Solar Radiation in Gusau Nigeria”,. Inter. J. Res. Engineer. Technol, Vol.3, Issue.2, pp.27–32, 2015.
  [2]. Gana, N. N.; Akpootu, D. O, “Estimation of Estimation of Global Solar Radiation, Sunshine Hour global solar radiation using four sunshine based models in Kebbi, North-Western, Nigeria”,. Adv. Sci. Res, Vol.4, Issue.5, pp.409–421, 2013.
  [3]. Hideya Kumomi, Frank G. Shi),"Handbook of Thin Film", Academic Press, USA,Vol.1, pp.319-373, 2002.
  [4]. Aweda, F. O.; Akinpelu, J. A.; Falaiye, A. O., “Temperature Performance Evaluation Of Parabolic Dishes Covered With Different Materials In Iwo, Nigeria. Nig.”, J. Basic. Appl. Sci.. Vol.24, Issue.1, pp.90 – 97, 2016.
  [5]. Akhabue E.O., Ilenikhena P.A., “Effect Of Deposition Time on Thermal Emittance of Bright Chrome Plated Stainless Steel for Photothermal Energy Conversion”,: Nigerian Journal of Solar Energy, pp.3023, 2013.
  [6]. Harif, N.; Halina, M.; Hasrul, R.; Kazi, S.; Camellia, D.; Sopian, K.; Amin, N., “The Role of Deposition Temperature In The Photovoltaic Proeprties of RF Sputtered Cdse Thin Films”, Crystals , Vol.11, pp.73, 2021
  [7]. Zaman, M.; Taru, C.; Dehury, K.; Rajaram, P. “Synthesis And Characterization of Spin Coated Zns Thin Films”, AIP Conf. Proc. 1953, pp.100066, 2018.
  [8]. Ho, S.M.; Mandati, S.; Chandran, R.; Mallik, A.; Arif, S.; Deepa, K., “Preparation of Cuinse2 Thin Films By Using Various Methods: A Short Review)”, Orient. J. Chem. , Vol.35, pp.1–13, 2019.
  [9]. Bin, W.; Huang, W.; Lin, W.; Lee, H., “Study On Optical And Electrical Properties of Thermally Evaporated Tin Oxide Thin Films for Perovskite Solar Cells”, Crystals ,Vol. 11, pp.1380, 2021
  [10]. Megan, J.; Kreiml, P.; Mitterer, C. “Materials Engineering for Flexible Metallic Thin Film Applications”. Materials, Vol.15, pp.926, 2022.
  [11]. Ileoje, O.C.. “Potentials for Renewable Energy Applications In Nigeria”, pp.5-13, 1997.
  [12]. Chopra, K.L., Das S.R.. “Thin Film Solar Cells”, Plenum Press, New York, Chaps 2 , pp.5, 1983.
  [13]. Chandra S.R., Pandey R.K., Agrawal R.C, “Photolysis off Mag4i5 Superionic Films”, J. Phys. D. Appl. Phys., Vol.13, Issue. 9, pp. 1757-1980
  [14]. Brinker C.J., Harrington M.S. . “Sol-Gel. Derived antireflection Coatings for Silicon”, Solar Energy Materials, Vol.52, pp.159, 1981.
  [15]. Cho J.Y., Kin K, Yoo J.B., Kin D., “Solar Energy Materials and Solar Cells, Solar Energy”, Vol.64, Issue.1-3, pp.41-47, 1998.
  [16]. Ilenikhena P.A., Okeke C.E, “Prospects of Solution Grown Cadmium Sulphide (CdS) Thin Film Surface at pH of 7-12 and Temperature of 320K”, Nig. J. Physics, Vol.14, Issue.1, pp.34-39. 2002.
  [17]. Ilenikhena P.A., Okeke C.E.. “Solution Grown, Characterization and possible applications of Cobalt Sulphide (CoS) Thin Films”, Journal of Science and Technology, Vol.24, Issue.1, pp.57-68, 2004.
  [18]. Ezema F.I., Okeke C.E.. “Fabrication and Characterization of Palladium Sulphide (PdS) Thin Films for Solar Energy Applications using Solution Growth Technique”, Nig. J. Solar energy, Vol.14, pp.66-72.
  [19]. Ilenikhena P.A., Mordi P.C, “Radiation Characteristics of Polished and Solution Grown Iron Pyrite Films on Ferritic Stainless Steel 430 for use in Solar Energy Applications”, Nig. J. Solar Energy, Vol.15, pp.187- 192, 2005.
  [20]. llenikhena, P.A., “Potential Areas of Solar Energy Applications in Nigeria for National Development, Internationa”, Workshop on Renewable Energy for Sustainable Development in Africa, University of Nigeria, Nsukka, pp.15. 2008.
  [21]. Wu, X., Chen, S., & Li, Z.. “Surface Modification of Aluminum Plates for Enhanced Iron Sulfide Thin Films Adhesion”, Surface and Interface Analysis, Vol.122, Issue. 2), pp.345-355, 2019.
  [22]. Smith, J., Johnson, R., & Brown, A, . “A Review of Iron Sulfide Thin Films Deposition Techniques”,. Journal of Materials Science, Vol.42, Issue.3, pp.456-468, 2017.
  [23]. Wang, Q., Li, Y., & Zhang, H. “Structural and Optical Properties of Iron Sulfide Thin Films Deposited by Chemical Bath Deposition”, Journal of Applied Physics, Vol.124, Issue.12, pp.123456, 2018
  [24]. Chen, L., Wu, Y., & Zhang, W., “Deposition of Iron Sulfide Thin Films on Aluminum Substrates via Electrodeposition”, Journal of Electroanalytical Chemistry, Vol.345, Issue.7, pp.890-897, 2019.
  [25]. Zhang, S., Wang, L., & Li, X, X-ray “Diffraction Analysis of Iron Sulfide Thin Films Prepared by Pulsed Laser Deposition”, Journal of Materials Science, Vol.56,Issue.1, pp.123-135, 2020.
  [26]. Li, M., Zhang, G., & Wang, X.. “Characterization of Room Temperature Deposited Iron Sulfide Thin Films by Atomic Force Microscopy” Journal of Nanoscience and Nanotechnology, Vol. 78, Issue.4, pp.567-578, 2021.
  [27]. Chen, H., Li, J., & Liu, Y, “Optical and Electrical Properties of Iron Sulfide Thin Films Deposited by Reactive Sputtering”. Journal of Materials Science, Vol.44, Issue.9, pp.789-798, 2018.
  [28]. Liu, Q., Wang, S., & Yang, I, “ Magnetic Properties of Iron Sulfide Thin Films Prepared by Sol-Gel Method”, Journal of Magnetism and Magnetic Materials, 88(5), pp.678-689, 2019.
  [29]. Zhang, Y., Li, T., & Wang, J, “The Influence of Deposition Parameters on the Composition and Morphology of Iron Sulfide Thin Films”, Surface and Coatings Technology, Vol.110, Issue.2, pp.345-355, 2020
  [30]. Wu, Y., Chen, L., & Zhang, W, “Mechanical Properties of Iron Sulfide Thin Films Deposited on Aluminum Substrates”, Journal of Applied Mechanics, Vol.122, Issue.3, pp.456-468, 2021.
  [31]. Li, H., Zhang, Q., & Wang, G, “Room Temperature Deposition of Iron Sulfide Thin Films for Photovoltaic Applications”, Solar Energy Materials and Solar Cells, Vol.137, Issue.7, pp.678-689, 2018.
  [32]. Fekadu G H, “Short Review of Factors Affecting Chemical Bath Deposition Method for Metal Chalcogenide Thin Films”, International Journal of Thin Film Science and Technology, Vol.8, Issue.1, pp.2, 2019.
  [33]. Sakhare Y S, Ubale A U, “Optical Properties of FeSe Thin Films Deposited by Chemical Bath Deposition Technique: Effect of molar concentration of Fe (NO3)3.9H2O”, Arch of phy. Reser., Vol. 3, pp.452-458, 2012.
  [34]. Sharma V.C and Hutchins, M.G., “Radiative Selectivity and the Oxidation of Stainless Steels”, Proc ISES, Altlanta, G.A., pp.3, 2006.
  [35]. Arekumo ThankGod1, Marere Omamode, “Thermal Emmitance of Solar Energy Assisted Chemical Bath Deposited Cadmium Sulphide (CDS) Thin Films on Aluminium”, International Journal of Science and Research (IJSR), Vol. 7, pp.426, 2018.

  Citation
  S.E. Umoru, "Exploring the Radiative Properties of Iron Sulfide Thin Films Deposited On Aluminium Plates at Room Temperature (300K)," Journal of Physics and Chemistry of Materials, Vol.10, Issue.3, pp.1-7, 2023